Troubleshooting Table - Inventum IKI7028 Benutzerhandbuch

TROUBLESHOOTING TABLE

Problem
The appliance does not start.
The operation indicator on the
control panel shows U.
A cooking zone switches off
automatically. The operation
indicator shows H.
The operation indicator on the
control panel shows Lo.
BREAKDOWN CODES
The breakdown codes are shown on the timer indicator on the control panel.
Breakdown code
E3 / E6
E7 / E8
U
The appliance or a cooking
zone has turned itself
off unexpectedly, a tone
sounds and a breakdown
code is displayed.
38 • English
Possible cause
There is no mains supply.
The appliance is locked.
The touch buttons are covered with
water or dirt.
There is no pan on the cooking zone. Put a pan on the cooking zone.
The pan is not suitable for an
induction appliance.
The maximum cooking time is
reached. Refer to section
switch-off times .
The appliance is locked.
Possible cause
The appliance is overheated.
There is a defect in the mains supply.
There is no pan on the appliance or the pan is
not suitable for an induction appliance.
A technical defect.
Possible solution
• Do a check if the mains plug is
correctly connected to the mains
socket.
• Make sure that the mains supply
is on.
Unlock the appliance. Refer to
Locking and unlocking the
section
appliance .
Clean the appliance. Refer to section
Daily cleaning
Use a pan that is suitable for an
induction appliance. Refer to section
Requirements for pans
1. Start the appliance. Refer to
section
Automatic
2. Select a cooking zone. Refer to
section
Unlock the appliance. Refer to
Locking and unlocking the
section
appliance
.
Possible solution
Let the appliance cool down before
restarting it.
Do a check on the voltage of the
mains supply.
Place a pan or use a pan that is
suitable for an induction appliance.
Refer to section
pans
.
Please write down the breakdown
code, unplug the appliance and
contact Inventum-servicedienst.
.
.
Starting the appliance
.
Using a cooking zone
.
Requirements for