Removing The Appliance; Operation; Preparing For Operation; Starting The Appliance - Inventum IKI3008 Benutzerhandbuch

5. Install the fastening brackets (A) to the appliance. Use the screws.
6. Put the appliance in the opening of the worktop.
7. Connect the appliance to the mains supply.
After connecting the display lights up for a short time. The appliance is ready for use.

REMOVING THE APPLIANCE

1. Disconnect the appliance from the mains supply.
2. Push the appliance up to remove it.
5

Operation

The appliance has electronic sensors that activate when you touch the buttons on the control panel. The appliance
makes a sound when a control is touched.
Caution:
Only use pans that are suitable for an induction appliance. Refer to section

PREPARING FOR OPERATION

1. Clean the appliance before operation. Use a damp cloth.

STARTING THE APPLIANCE

1. Touch the on/off button to start the appliance. The indicators show "-"/ "--".
Note:
If you do not select a cooking zone within 1 minute, the appliance automatically switches off.
USING A COOKING ZONE
Selecting a cooking zone
1. Put a pan on the cooking zone.
2. Touch the selection button of the cooking zone.
3. Touch the slider to increase and decrease the power level. The operation indicator shows the set power level.
Note:
If you do not select a power level within 1 minute, the appliance automatically switches off.
Stopping a cooking zone
1. Touch the slider to decrease the power level to 0.
Note:
The operation indicator shows H to indicate the cooking zone is still hot.
Note:
Always lift the pan off the appliance, do not slide it, or it may scratch the glass.
32 • English
(Figure 12)
Requirements for pans
.