Removing The Appliance; Operation; Preparing For Operation; Starting The Appliance - Inventum IKI6008 Benutzerhandbuch

6. Put the appliance in the opening of the worktop.
7. Connect the appliance to the mains supply.
After connecting the display lights up for a short time. The appliance is ready for use.

REMOVING THE APPLIANCE

1. Disconnect the appliance from the mains supply.
2. Push the appliance up to remove it.
5

Operation

The appliance has electronic sensors that activate when you touch the buttons on the control panel. The appliance
makes a sound when a control is touched.
Caution:
Only use pans that are suitable for an induction appliance. Refer to section

PREPARING FOR OPERATION

1. Clean the appliance before operation. Use a damp cloth.
MAXIMUM POWER
The appliance has a maximum power of 3500 watts. The power will be divided between all four cooking zones. It is
possible that the maximum available power for the cooking zones together is exceeded. This can cause "switching"
of the power between the cooking zones. In that case, the power of the second cooking zone will be decreased
automatically. When you use three or four cooking zones at once, the power level will decrease even further down.
The corresponding operation indicator will flash to show necessary power reduction. It flashes for 3 seconds and
during that time further adaptations of the setting are allowed before the power is automatically reduced.
NOTE: when you have one cooking zone on power level 9, you can add a second cooking zone on
maximum power level 8. When another cooking zone is added, the power levels of the other two cooking
zones will further decrease.

STARTING THE APPLIANCE

1. Touch the on/off button to start the appliance. The indicators show "-"/ "--".
Note:
If you do not select a cooking zone within 1 minute, the appliance automatically switches off.
USING A COOKING ZONE
Selecting a cooking zone
1. Put a pan on the cooking zone.
2. Touch the selection button of the cooking zone.
3. Touch the slider to increase and decrease the power level. The operation indicator shows the set power level.
Note:
If you do not select a power level within 1 minute, the appliance automatically switches off.
32 • English
'Requirements for pans'
.