Safety Provisions; Installation; Unpacking; Preparing For Installation - Inventum IKI7028 Benutzerhandbuch

Item
On/off button
Booster button
Timer indicator
Timer button

SAFETY PROVISIONS

Pan detection mode
With the pan detection mode, the appliance does not work if you use an unsuitable pan or if the appliance does not
detect a pan on a cooking zone. The operation indicator shows U and it is not possible to increase the power level.
Residual heat indicator
After stopping the appliance, the cooking zones stay hot. If you touch a hot cooking zone this may result in injury.
The operation indicator shows H to indicate the cooking zone is hot. When the cooking zone is cool, the operation
indicator no longer shows H.
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION
• Make sure that the appliance is assembled correctly. Incorrect assembly may lead to dangerous situations. The
installer is liable for damage caused during incorrect assembly.
• Only a qualified electrician is allowed to electrically connect the appliance.
• The appliance must be installed according to national and regional safety instructions.
• The appliance has protection class I and may only be used in combination with an earthed connection.
The manufacturer is not liable for unsuitable operation and possible damage caused by unsuitable electric
installations.
• The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• The appliance may only be installed above a drawer or an oven with forced ventilation. There must be a minimum
distance for ventilation.
• Do not install the appliance above a refrigerator, oven without ventilation, washing machine or dishwasher.
• Make sure that the mains cable does not get jammed during installation or is running along sharp edges. If an
oven is installed below it, make sure that the mains cable goes via the rear corners of the oven to the connection
box. The mains cable must be placed in such a way that no contact is made with hot parts of the appliance or the
oven.
• The connection point, mains socket and/or mains plug must always be accessible.
• The worktop on which the appliance is placed must be flat, horizontal and stable. Observe the instructions from
the manufacturer of the worktop.
• In case of incorrect installation or connection, the warranty becomes invalid.
• Any change to the appliance, including replacement of the mains cable, must be performed by a certified installer.

UNPACKING

1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.

PREPARING FOR INSTALLATION

1. Make sure that there is sufficient space available around the appliance.
Function
To start or stop the appliance.
To activate or deactivate the booster mode.
To show the set time.
To use the timer.
(Figure 4)
English • 31