Connecting The Appliance; Installing The Appliance - Inventum IKI7028 Benutzerhandbuch

2. Make sure that the worktop is prepared according to the dimensions of the appliance (A and B).
Note:
Keep a safety distance of at least 3 mm between the sides of the hob and the inner
surfaces of the worktop.
MAKING VENTILATION OPENINGS
The electronics in the appliance require cooling. The appliance will automatically switch off when there is insufficient
ventilation.
Caution:
Do not block the ventilation openings of the appliance.
Making the openings
1. Make an opening at the rear of the kitchen unit. Make sure that there is a space of 20 mm
between the back wall and any drawers.
2. Also keep 20 mm of space when there are no drawers, but an oven.
3. Make sure that there is a space of 50 mm between the appliance and the drawer or oven.
Refer to Figure 8 and 9.
4. Make sure that the worktop has a minimum thickness of 30 mm. Refer to Figure 8 and 9.
5. Make sure the cross bar does not hinder the air flow. Cut or saw the cross bar diagonally if
necessary.

CONNECTING THE APPLIANCE

The appliance is supplied with a mains cable and uses a 5-pin Perilex plug (not included).
1. Make sure that the electrical system is suitable for the load of the appliance.
2. Make sure that the mains socket is grounded.
3. Connect the appliance according to the wiring diagram in Figure 11 or 12.
Warning:
Connecting according to the wiring diagrams may only be performed by a certified
installer.

INSTALLING THE APPLIANCE

Preliminary requirements
• Make sure that the installation surface is prepared according to the correct dimensions.
• Make sure that the ventilation openings are made.
Procedure
1. Remove any dirt from the worktop.
2. Apply a sealant to the edges of a wooden or plastic worktop to prevent damage as a result of moisture.
32 • English
(Figure 5)
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
(Figure 10)
(Figure 11)
(Figure 12)