Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch PFZ 700 PE Originalbetriebsanleitung

OBJ_BUCH-648-003.book Page 16 Monday, September 14, 2009 10:23 AM
16 | English

Technical Data

All purpose saw
Article number
Rated power input
Output power
Stroke rate at no load n
0
Tool holder
Stroke rate control
Orbital action
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
Weight according
to EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 86 dB(A);
Sound power level 97 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting wood: Vibration emission value
2
a =10 m/s , Uncertainty K=2.5 m/s
h
2 609 932 703 | (14.9.09)
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
PFZ 700 PE
may be used to compare one tool with another.
0 603 362 7..
It may be used for a preliminary assessment of
exposure.
W 710
The declared vibration emission level repre-
W 440
sents the main applications of the tool. However
-1
min 500 – 2600 if the tool is used for different applications, with
different accessories or poorly maintained, the
SDS
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
mm 28
tion should also take into account the times
when the tool is switched off or when it is run-
mm 195
ning but not actually doing the job. This may sig-
mm 20
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
kg 3.4
as: maintain the tool and the accessories, keep
/II
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
2
.
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
24.07.2009
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools