Bosch PFZ 700 PE Originalbetriebsanleitung Seite 17

OBJ_BUCH-648-003.book Page 17 Monday, September 14, 2009 10:23 AM
Assembly
Replacing/Inserting the Saw Blade
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
When changing the saw blade, take care
that the saw blade holder is free of material
residue, e. g. wood or metal shavings.
Selecting a Saw Blade
Use only saw blades suitable for the material be-
ing worked.
An overview of recommended saw blades can
be found at the end of these operating instruc-
tions. The saw blade should not be longer than
required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Press the slider for SDS saw blade release 3
downward and insert the saw blade 1 into the
SDS saw blade holder to the stop.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to inju-
ries.
Removing the Saw Blade
Press the slider for SDS saw blade release 3
downward and pull the saw blade 1 out.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
Bosch Power Tools
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation
Operating Modes
Before any work on the machine itself, pull
the mains plug.
Orbital Action Settings
The four orbital action settings allow for optimal
adaptation of cutting speed, cutting capacity
and cutting pattern to the material being sawed.
The level of orbital action can be set with rotary
switch 7, even during operation.
Orbital action switched off (level 0):
For working thin or hard material
such as sheet metal or steel.
For achieving clean cutting edges.
Orbital action level I:
For working non-ferrous metals,
hardwood, plastics or materials of
medium density.
Orbital action level II:
For working with soft materials such
as light building materials, insulation
material, etc.
Orbital action level III:
For working with soft materials such
as soft wood or tree wood.
Pivoting Footplate (see figure B)
Due to its movability, the adjustable footplate 2
adapts to the required angular position of the
surface.
2 609 932 703 | (14.9.09)
English | 17