Functional Description; Intended Use; Product Features - Bosch GST Professional 85 P Originalbetriebsanleitung

OBJ_BUCH-431-004.book Page 17 Friday, July 3, 2009 11:37 AM
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Bosch Power Tools

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Rotatable top handle with pushbutton
(insulated gripping surface)
2 Thumbwheel for stroke rate preselection
(GST 85 PE)
3 Allen key
4 On/Off switch
5 Switch for sawdust blowing device
6 Adjusting lever for orbital action
7 Base plate
8 Guide roller
9 Saw blade*
10 Contact protector
11 Handle (insulated gripping surface)
12 Stroke rod
13 Splinter guard*
14 Scale for mitre angle
15 Screw
16 Angle gauge**
17 Bolt hole
18 Positioning pin/mark
19 Lead for the parallel guide
20 Locking screw for parallel guide*
21 Parallel guide with circle cutter*
22 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
**Commercially available (not included in the deliv-
ery scope)
English | 17
1 609 929 S94 | (3.7.09)