Bosch GST Professional 85 P Originalbetriebsanleitung Seite 19

OBJ_BUCH-431-004.book Page 19 Friday, July 3, 2009 11:37 AM
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
09.06.2009
Assembly
Before any work on the machine itself, pull
the mains plug.
Replacing/Inserting the Saw Blade
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Before inserting the saw blade 9, set the adjust-
ing lever for orbital action 6 to setting III.
– Press the orange pushbutton in the rotatable
top handle 1 down until it can be felt to en-
gage.
– Turn the rotating handle 1 approx. three
turns in the direction of the arrow.
Bosch Power Tools
– Insert the saw blade 9 lateral to the cutting
direction into the stroke rod 12.
– Turn the saw blade 9 so that the toothing fac-
es toward the cutting direction. Pull the saw
blade 9 a little downward until it engages.
– Turn the rotating handle 1 in the direction of
the arrow until a click can be heard.
– Push up the orange pushbutton at the rotat-
able top handle 1 again to the starting posi-
tion.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to inju-
ries.
Splinter Guard (see figure B)
The splinter guard 13 (accessory) can prevent
fraying of the surface while sawing wood. The
splinter guard can only be used for certain saw
blade types and only for cutting angles of 0°.
When sawing with the splinter guard, the base
plate 7 must not be moved back for cuts that are
close to the edge.
Press the splinter guard 13 from the bottom into
the base plate 7.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
English | 19
1 609 929 S94 | (3.7.09)