Klarstein ROYAL FLUSH Bedienungsanleitung Seite 27

EN
Using the extractor hood as an exhaust air hood (with air extracted to
outdoors)
If the extractor hood has been fitted at the factory with a carbon filter, this must be
removed. It is only practicable to use this when operating your hood in circulation
mode.
Converting the extractor hood to a circulation hood
If you wish to use an appropriately fitted hood as a circulation hood, you must
mount the active carbon filter(s) to the fan motor before using the hood. The
active carbon filter(s) is/are included in the scope of supply with some models.
Otherwise you must obtain the active carbon filter(s) from the supplier of your
extractor hood. You must also change your hood over to the „Filter position" at the
device provided (lever or ball handle).
Electrical connection
Before connecting the extractor hood, check that the voltage stated on the rating
plate (V) agrees with the supply voltage in your home. Never install the appliance if
the data on the rating plate does not agree with your supply voltage. You will find
the rating plate inside the appliance, behind the grease filter.
If the appliance is not fitted with a connector plug, a two-pole switch, conforming
to standards with a minimum open contact gap of 3 mm is to be installed by an
authorized tradesman in an easily accessible location. If the extractor hood is
fitted with a standard connector plug, connect this to an easily accessible standard
socket.
Mounting the carbon filter
You will find the mounting instructions for the carbon filter in its packaging. To
mount the carbon filter, remove the grease filter(s), fit the carbon filter according
to its mounting instructions and refit the grease filter(s).
27