NovoPress Novipro ACO103 BT Betriebsanleitung Seite 24

8.2 Meaning of the LED display
EN
LED display
All LEDs off.
Green LED (2) lights up.
Green LED (2) off
(pressing operation in
progress).
Green LED (2) flashes.
Green LED (2) flashes.
Green LED flashes.
(Press device
automatically returns to
initial position.)
Green LEDs (4)
Blue LED (10) flashes.
Blue LED (10) lights up.
Red LED (3) flashes.
Red LED (3) lights up.
Red (3) and green (2)
LED flash alternately.
ACO103 BT
Status/cause
The device is switched off.
On standby.
Automatic press cycle is on,
device ends the pressing
operation automatically.
Insufficient battery charge.
Retaining pin not correctly
shut.
Retaining pin has come
loose!
Battery charge display
The press device is ready
for connection.
The press device is
connected with the
NovoCheck app.
Device not within the
temperature range
Device fault.
Service interval reached.
20
Measure
Briefly press the start button (1) (see
section 7.7).
Charge or replace battery.
Insert retaining pin, or check retaining pin
and cylinder.
Insert retaining pin, or check retaining pin
and cylinder.
NOTE
The pressing operation may not have
been completed; please check and repeat
if necessary.
The press device can be connected with
the NovoCheck app.
The device only works within a
temperature range of -10 to +50°C. If the
red LED is flashing, the device must be
moved into a warmer or colder area. The
device can be warmed to operating
temperature by means of dry runs.
If the device is too warm it must be cooled
down by means of a short break.
Press the start button (1). If this is
unsuccessful, the press device is
defective.
Send the device to a specialist workshop.
NOTE!
The pressing operation may not have
been completed; please check and repeat
if required.
Take the press device to be serviced.