Werbung
INSTALLATION GUIDES- LUPOL03
INSTALLATION INFORMATION
Installation must be carried out in
accordance with national standards.
The fi xture must only be used when
complete with safety screen. If the
screen is damaged or broken, the fi xture
must not be used. Restore the original
conditions before reusing.
The fi xture is installed under CL II (or
CL I) protection standards, particular
care must be taken while assembling to
ensure that exposed metal parts do not
come into electrical contact with parts of
the electrical installation connected to
a protection conductor. This light fi xture
must be installed only for the use for
which it was designed, namely for the
illumination of outdoor spaces.
Any other use must be considered to
be improper and dangerous, and the
manufacturer cannot be held liable for
any damage caused by improper and
unreasonable use.
Installation
Unscrew the two screws (M6), the
nuts and the two washers at the upper
connection slots (Fig. 1-2-3).
Fasten the light fi tting to the support
cable (Fig. 4) and tighten the four screws
(M6) on the bracket (Fig. 5).
Electrical connection
Connect the power cable (Fig.). 6-7-8).
If the external fl exible cable of this
appliance is damaged, it must only be
replaced by the manufacturer, its service
agent or a qualifi ed person to avoid
danger.
Fasten the safety cable to the support
cable (Fig. 9). The bracket is equipped
with a central element with a ± 15° tilting
system to adjust the correct vertical
position of the luminaire.
To adjust, unscrew the two nuts (Fig. 10),
proceed with the relevant adjustment
(Fig. 11) and retighten the two nuts
(Fig. 12).
EN
neri.biz
43
Werbung
