Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installations for instructions
1. Preparing for installation
Read these assembly instructions carefully and keep them within reach when
using the sauna so that you can look up product information at any time.
These installation instructions can also be found in the downloads section
of our website: www.sentiotec.com/downloads.
1.1. Important note
● Before you begin work, check the parts list to ensure that all the individual
parts have been delivered. If you discover any missing parts, notify your
dealer within 14 days of receiving the sauna cabin.
● The room that the sauna is installed in must be dry and ensure an appropriate
amount of air circulation.
● The floor must be level and even, preferably a stone or tiled floor.
● A minimum room height of 230 cm is required for the cabin installation work.
● A distance of at least 5 cm from the wall must be maintained.
● The inside of the wooden parts used must not be handled with any impreg-
nating material.
● Wood is a natural product that can swell, shrink or warp, despite good stor-
age. For this reason, some force may be necessary during the installation.
● Air circulation in the sauna cabin is crucial for correct function. Please observe
the dimensions for the air intake and outlet vents specified by the manufacturer
of the sauna heater. If necessary, cut a rectangular cutout into the base frame
before installation; holes can also be made later using a drill.
● All screw fittings must be pre-drilled.
● You need an assistant for assembly.
Attention!
The electrical connection may only be performed by a qualified electrician
or similarly qualified person.
p. 3/12
EN
Werbung
Inhaltsverzeichnis
