Stiga MPST 84 Li 48 V1 Kurzanleitung Zum Gebrauch Seite 80

PROBLEM
The icons in fig. 13.E and fig. 13.O
remain ON, battery LEDs 1, 2, 4 and
5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The icons in fig. 13.E and fig. 13.O
remain ON, battery LEDs 1, 2, 3 and
5 flash.
Pushbutton panel type "I" and "II"
Pushbutton panel of type "III"
The battery LEDs in fig. 13.F turn ON
and OFF in sequence, from left to right,
and vice versa.
NOTE For machines equipped with type "III" push-button
panel, together with the LED error combination, a numeric er-
ror code is displayed in the battery charge percentage digits
(fig. 13.Y). If necessary, provide the numerical error code to the
Authorized Service Centre.
Cause
The machine starts with the drive pedal
not released (not in neutral position).
Drive engagement/disengagement
lever in drive disengaged position.
Communication error between on-board
electronic modules.
NOTE For further problems not listed in the table, contact an
authorised service centre immediately.
EN - 11
Solution
Switch off the machine and repeat the
starting procedure only after having
checked that the drive pedal is in the
neutral position (pedal released).
Check the position of the drive
engagement/disengagement lever
and, if necessary, return it to the drive
engaged position.
If the problem persists, contact a Service
Centre.
Switch off the machine and repeat the
starting procedure
If the problem persists, contact a Service
Centre.