Cleaning And Care - Parkside HG04967 Kurzanleitung

product. Otherwise the load on the product
may become unbalanced and cause it to
tip over. This may result in injury and / or
damage.
Store the product in a dry location, out of
the reach of children.
CAUTION! Do not lift or move the product
when weighed down in any way.
The load on the product must not
exceed 35 kg. Failure to observe
35 kg
this advice may result in injury
and / or product damage.
Only use the product in areas protected
from rain.
Do not use the product as a work platform.
Only fold the tables at the lowest height
setting.
Verify the spring bolts are firmly in place
before every use.
Dispose of defective, no longer usable
tables according the local regulations.
Installation (Fig. A‒F)
1. First unfold the table legs
Fig. A).
2. Select the desired table height and lock in
place with the spring bolts
3. Pull the hinges upwards until flat (see Fig. C).
Slide the locking clips
ensure they are stable.
Connecting the tables
together
Arow of tables can be connexted with below
method (see Fig. D):
1. Remove the plastic end caps
connection side for the first table.
2. On the second table, remove the plastic end
caps insert the metal plate
7
slot and tighten with the nut
sert the other side of the metal plate
the first table.
in pairs (see
5
(see Fig. B).
1
over the hinges to
10
at the
7
into the
6
. And then in-
9
into
6
3. Secure the connection by pressing the plastic
locking plug into the hole.
11
4. Repeat above process if you want to connect
more tables.
Remark: Tables in different angle combination
can also be connected. The connection brackets
can be clipped under two tables (see Fig. E).
8
Remark: There are many possibilities to combine
the tables (see Fig. F). Please note it may be not
possible to use the connection brackets
some cases.

Cleaning and care

To remove more stubborn dirt, use a damp
cloth and, if necessary, a mild cleaning agent.
in
8
GB/IE 9