Cleaning, Maintenance And Storage; Disposal And Recycling; Transport - Parkside PUG 1600 A1 Bedienungs- Und Sicherheitshinweise

If your machine has different hole spacing for mounting, use the
crossbars (C) provided as an adapter. (fig. 9-11)
• Connect the crossbars (C) with the support arms (B) and
secure them with 4 hexagonal screws (E), 4 washers (G), 4
spring washers (H) and 4 hexagonal nuts (I).
• Place your tabletop machine on the crossbars (C).
• Fasten the tabletop machine with 4 hexagonal screws (F), 4
washers (G), 4 spring washers (H) and 4 hexagonal nuts (I)
on each of the crossbars (C).
• Tighten the screws after assembly.
• Fasten the support arms with the mounted tabletop machine
on the universal tool stand, as described in point 8.2.
8.5 Using the workpiece stops (fig. 12)
The workpiece supports (D) have integrated workpiece stops
(D.2), which can be used to saw multiple pieces of wood to
the same length.
• Loosen the star-grip screw (K) on the desired side of the uni-
versal tool stand and adjust the height of the workpiece sup-
port (D) such that the support surface (D.2) is at the same
height as the workpiece support of the saw.
• Loosen the star-grip screw (J) to slide the workpiece support
horizontally.
• Set the desired distance between the saw blade and the stop
surface (D.1).
• Lock your setting by tightening the star-grip screws (J) again.

9. Cleaning, maintenance and storage

m Important!
Before any cleaning or maintenance work, the electrical tool
fitted must be switched off and the mains plug pulled out! Risk
of injury!
9.1 Cleaning
• Keep the universal tool stand as free of dust and dirt as pos-
sible. Rub the universal tool stand clean with a clean cloth or
blow it off with compressed air at low pressure.
• We recommend that you clean the universal tool stand im-
mediately after every use.
• Clean the device at regular intervals using a damp cloth
and a little soft soap. Do not use any cleaning products or
solvents - they could attack the plastic parts of the universal
tool stand.
9.2 Storage
m Attention!
Store the universal tool stand only in dry locations that are inac-
cessible for unauthorised persons.
22 GB

10. Disposal and recycling

The equipment is supplied in packaging to prevent it from be-
ing damaged in transit. The raw materials in this packaging
can be reused or recycled. The equipment and its accesso-
ries are made of various types of material, such as metal and
plastic. Defective components must be disposed of as special
waste. Ask your dealer or your local council.
The packaging is wholly composed of
environment ally-friendly materials that can be
disposed of at a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.

11. Transport

m Attention!
Do not transport whilst the electric power tool is running.
Before transporting the universal tool stand, pull out the mains
plug of the electric power tool mounted on it! Risk of injury
due to electric shock and unexpected start-up of the electric
power tool!
Two people can lift the universal tool stand by its frame bed
in order to move the universal tool stand within rooms (do not
drag it along the ground).
If being transported in a vehicle, remove the electric power
tool first.
Fold up the legs for transport.
Ensure that the load is well secured if transporting the universal
tool stand in a motor vehicle.