MAXXMEE JC-220D Bedienungsanleitung Seite 18

EN
a cloth should therefore be placed
beneath the cleaning foot or parking
for a prolonged period of time
should be avoided.
1. Give the floor a sweep and / or vacuum
before using the device.
2. Assemble the device (see the "As-
sembly" and "Functions" chapters).
3. Fill the water tank (14) (see the "Filling
the Water Tank" chapter).
4. To unwind the connecting cable, pull
out the upper hook for winding up the
cable (2) a little and turn it down.
5. Place the device upright and tilt the
handle pole (3) forwards towards the
cleaning foot (11) until the joint (12) of
the cleaning foot engages.
6. Adjust the steam quantity control (13)
to the lowest setting by turning it as
far as it will go anticlockwise.
7. Plug the mains plug into an easily
accessible plug socket.
8. Move the On / Off switch (16) to the I
position. The control lamps (8) behind
the water tank light up red. Wait until
the device has reached operating
temperature and the control lamps
light up blue. Steam begins to
emerge from the cleaning foot.
9. The quantity of steam can be adjusted
by turning the steam quantity control.
Please Note: When the steam quantity
control is turned, it takes a few seconds
for the quantity of steam to adjust.
10. Press the On / Off button (9) on the
cleaning foot to activate the vibrating
function.
11. Hold the device securely by the
handle (1) and tilt it backwards slightly
to release the locking mechanism
in the joint of the cleaning foot. If
necessary, hold the cleaning foot with
your own foot as you do this.
18
01589_Inlay_DE-EN-FR-NL_A5.indb 18 01589_Inlay_DE-EN-FR-NL_A5.indb 18
12. Guide the cleaning foot slowly back
and forth over the floor. The floor is
cleaned as you do this.
L
The frame (6) has an additional
articulated joint (4) which allows
cleaning under items of furniture.
To do this, press the PUSH button
on the articulated joint to release
the locking mechanism (Picture C).
To return the handle pole to its
initial position, pull it up until the
articulated joint engages.
13. To deactivate the vibrating function,
press the On / Off button on the
cleaning foot again.
14. After use, move the On / Off switch to
the 0 position. The control lamps go
out.
Use as Handheld Steam Cleaner
Please Note!
■
Never attempt to smooth clothing on
people! Hang clothing on a hanger
with sufficient clearance on all sides so
that heat and moisture cannot cause
any damage to any living creatures or
objects. There is a danger of scalding.
1. Assemble the device (see the "As-
sembly" and "Functions" chapters).
2. Fill the water tank (14) (see the "Filling
the Water Tank" chapter).
3. Adjust the steam quantity control (13)
to the lowest setting by turning it as
far as it will go anticlockwise.
4. Plug the mains plug into an easily
accessible plug socket.
5. Move the On / Off switch (16) to the I
position. The control lamps (8) behind
the water tank light up red. Wait until
the device has reached operating
temperature and the control lamps
light up blue.
16.12.2021 11:58:56 16.12.2021 11:58:56