Air Inlet Filter; General Cleaning - clage Zip HydroTap G5 B 60 Gebrauchsanleitung

Filter Maintenance

Air Inlet Filter

The Zip HydroTap air fi lter is conveniently located on the outside of
the condenser. The fi lter screen is a sliding fi t in the plastic housing
on the side of the under sink unit. The screen may be removed for
cleaning, by sliding it forward. This needs to be inspected at least
quarterly, cleaned and replaced if damaged.
Note: For best performance the unit should only be operated with
a clean air fi lter screen, correctly fi tted in place. Maintain, at least,
a 50 mm air gap in front of the screen at all times. Take care not to
allow cloths or other soft materials to accidentally block the air inlet.
Slide to remove
Cleaning

General cleaning

Do not use strong, corrosive, spray or abrasive cleaners. The plastic
surfaces and taps should be wiped with a slightly wet and hygienic
cloth only.
Under sink units must never be located near, or cleaned with water
jets.
Avoid using air borne pesticides near the undersink unit.
We recommend cleaning the tap and the tap spout with CLAGE
Desinfekt at regular intervals. Article number: 4100-44145
37