clage Zip HydroTap G5 B 60 Gebrauchsanleitung Seite 30

LCD Screen Operation - Section B
Note: Hot steam may escape from the fi tting during calibration!
III. Dispense Times
DISPENSE TIMES
IV. Light Sensor (Classic- & Classic Plus only)
LIGHT SENSOR
CALIBRATION
This will calibrate the light sensor which will allow the
system to go to sleep when it is dark.
Before we start, the room should be in a typical
ambient lit environment.
Remove any object away from the tap.
Remove any refl ective or shadowing objects from around the fi x-
ture.
12:12 PM
Boiling
14
SEC
12:12 PM
Boiling calibration
The boiling point calibration is
started automatically during
initial commissioning and can be
repeated manually here. One run
takes approx. 10 minutes.
Booster
This function should only be
considered when a Booster unit is
installed.
Note: Failing to make the correct
selection for 'Booster' will eff ect
product performance.
For all taps with a fi lling function
and for each type of water, a
duration of 5 - 15 seconds can be
set here for automatic dispensing.
Follow the instructions on the
display. Before each calibration,
make sure that the ambient light
corresponds to the typical light-
ing conditions at the installation
site.
30