Temperature Settings - clage Zip HydroTap G5 B 60 Gebrauchsanleitung

LCD Screen Operation - Section B
TANK FLUSH
Hot Tank
Cycle 1/2
98.0 °C
Auto
Dispense
During the rinsing process, the tank contents must be emptied
several times through the tap. If the spout of your tap is above a
sink or a draining board with a drain, you can activate the automatic
dispense for this.
Note: When the automatic tap is active, water will fl ow out of the
tap several times without warning.
II. Temperature Settings
HOT SETPOINT
Boiling Set Point
Note: The fl ow rate of boiling water is aff ected by a higher tem-
perature setting. At a setpoint of 98 °C, up to 6 % less energy is
consumed in standby mode than at 100 °C.
When setting temperatures close to boiling point, the pump is at risk
of cavitation. This is indicated by a warning symbol.
12:12
Run:
12:12 PM
98
°C
Tank Flush
The tanks must be rinsed during
initial commissioning and after a
long period of non-use.
Start the rinsing process by
tapping on the green arrow and
follow the instructions on the
display.
This is where the water tempera-
tures are set for operation. Boiling
point calibration is recommended
for every change of location and
especially for locations at high
altitudes.
Hot water
Standard setpoint: 98 °C
Setpoint range: 68 - 100 °C.
Operation: Within 1 - 2 °C of the
setpoint.
29