clage Zip HydroTap G5 B 60 Gebrauchsanleitung Seite 23

Arc tap
Select the desired type of water by tipping to
on the Select button on the Zip lever at the
tap.
> Red: boiling water
Turn the lever to dispense water. When the
lever is turned back, water will fl ow as long
as the lever is held. If the lever is turned
forwards, water will fl ow continually for 5 to
15 seconds. This time can be set in the menu.
The lever then has to be manually returned to
the Off position.
(With the safety ON)
The safety button must be pushed twice within
one second. The red LEDs start to fl ash and
boiling water can be dispensed by turning the lever. After 3 seconds
without operation, the LEDs light up continuously and the tap is
locked again.
Note: When dispensing water at the Celsius Arc tap, pay attention to
the orientation of the swivel spout.
Safety Sensor Calibration (Classic only)
Light intensity varies from site to site, therefore it is recommended
that a re-calibration be performed at the time of the installation.
All direct natural sun light must be shaded from the HydroTap,
during the calibration. This can be achieved by closing any nearby
curtains, blinds and so on.
Safety sensor calibration
1. Shield the HydroTap from any
direct sun light e.g. using a dark
cloth.
2. Bring the unit in normal operating
mode.
3. Turn the power OFF.
4. Pull both tap levers to the forward
position.
5. Turn ON the power.
6. The unit will calibrate the safety
switch automatically.
7. Return the levers to the neutral
position.
Tap Operation
23
Zip lever
SELECT
SAFETY
Pull both levers
forward
Safety Safety
sensor sensor