Sharp K-60V19BQM-EU Bedienungsanleitung Seite 19

Deep Tray
Deep tray is used to cook stews.To lo-
cate the tray correctly in the cavity, put it
to any rack and push it to the back.
Removal of wire shelf
Pull the wire shelf as shown in the pictu-
re. After releasing it from clips, lift it up.
a
Removal of catalitic panel
Remove G screws on the each catalitic
enamel coated panel.
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
5
4
3
2
1
•
Insert the accessory to the correct
position inside the oven.
•
Allow at least a 1 cm space between the
fan cover and accessories.
•
Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
•
The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
•
Trays and wire grids can be positioned
on any level from 1 to 5.
•
Telescopic rails can be positioned on
levels T1, T2, 3, 4, 5.
•
Level 3 is recommended for single level
cooking.
•
Level T2 is recommended for single
level cooking with the telescopic rails.
•
The turnspit wire grid must be
positioned on Level 3.
•
Level T2 is used for the turnspit wire
grid positioning with telescopic rails.
****Accessories may vary depending on the
model purchased.
EN - 17
T2
T1