Specifications; Important Safety Instructions - Makita AF500HP Betriebsanleitung

ENGLISH
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency (times/min.)
5. Locking position
6. Released position
7. Lock lever
8. Trigger
9. Contact element
10. Adjuster
11. Too deep

SPECIFICATIONS

Dimensions (L X H X W)
Min. hose diameter
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Wear safety glasses.
............. Do not use on scaffoldings, ladders.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
• Always wear safety glasses to protect your eyes from
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only Always wear
safety glasses and face shield to protect your eyes
Explanation of general view
12. Flush
13. Too shallow
14. Lock lever
15. Slide backward
16. Contact top cover
17. Hole
18. Protrusion
19. Nose adapter
20. Place first the contact element
against workpiece.
21. Hook
Model
Air pressure
Nail length
Nail capacity
Net weight
from dust or nail injury. The safety glasses and the face
END106-2
shield should conform with the requirements of
AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
(Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous.
Handle the tool carefully. Do not operate when under
the influence of alcohol, drugs or the like.
ENB110-1
• General Tool Handling Guidelines:
(1) Always assume that the tool contains fasteners.
(2) Do not point the tool toward yourself or anyone
whether it contains fasteners or not.
(3) Do not activate the tool unless the tool is placed
firmly against the workpiece.
(4) Respect the tool as a working implement.
(5) No horseplay.
(6) Do not hold or carry the tool with a finger on the
trigger.
(7) Do not load the tool with fasteners when any one
of the operating controls is activated.
(8) Do not operate the tool with any power source
other than that specified in the tool operating/
safety instructions.
• An improperly functioning tool must not be used.
• Sparks sometimes fly when the tool is used. Do not use
the tool near volatile, flammable materials such as
22. Hex wrench 3
23. Driver guide cover
24. Screw
25. Drain cock
26. Air filter
27. Oiler
28. Pneumatic oil
29. Thinner
30. Stove
AF500HP
0.98 - 2.26 MPa (9.8 - 22.6 bar)
15 mm - 50 mm
100 pcs.
228 mm X 61 mm X 207 mm
5.0 mm or more
1.1 Kg
7