Specifications - Makita T221D Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Battery cartridge
1-2. Set plate
2-1. Nut
3-1. Tool end (A)
3-2. Material
3-3. Less than 2 mm (5/64")

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for pressing staples into construction
materials such as timbers.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration emission value determined according to
EN792:
Work mode : stapling wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Downloaded from www.Manualslib.com
Explanation of general view
4-1. Switch trigger
4-2. Safety lever
5-1. Sight window
6-1. Press
6-2. Slide backward
6-3. Plate spring
Model
Staple width
Applicable staples length
Staple magazine capacity
Dimentions (L x W x H)
Net weight
Rated voltage
) : 77 dB(A)
pA
Wear ear protection
2
) : 4.5 m/s
h
2
manuals search engine
10 mm, 13 mm, 16 mm, 19 mm, 22 mm
199 mm x 58 mm x 193 mm
ENE054-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG904-1
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Cordless Stapler
Model No./ Type: T221D
ENG901-1
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
7-1. Staples
8-1. Plate spring
8-2. Press
8-3. Push
T221D
10 mm
100 pcs
1.8 kg
D.C. 9.6V
Corporation as the responsible
ENH101-14