Specifications; Additional Safety Rules For Tool - Makita BST110 Betriebsanleitung

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Trigger
5. Lever
6. Sub magazine

SPECIFICATIONS

Applicable staples length
Staple magazine capacity
Dimensions (L x W x H)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for pressing staples into construction
materials such as timbers.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Always wear safety goggles or safety glasses with
side shield, and a full face shield when needed.
2. Do not point the ejection port at anyone in the
vicinity (especially his face). Keep hands and feet
away from the ejection port area.
3. Always remove the battery cartridge before
loading the staples, adjustment, inspection,
maintenance or after operation is over.
4. Make sure no one is nearby before operation.
Never attempt to drive staples from both the
inside and outside of wall at the same time.
Staples may rip through and/or fly off, presenting
a grave danger.
5. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
6. Check walls, ceilings, floors, roofing and the like
carefully to avoid possible electrical shock, gas
4
Explanation of general view
7. Locking lever
8. Press
9. Main magazine
10. Staples
11. Groove
12. Hook
Model
Staple width
Net weight
leakage, explosions, etc. caused by stapling into
ENE054-1
live wires, conduits or gas pipes.
7. Use only staples specified in this manual. The use
of any other staples may cause malfunction of the
tool.
8. Do not tamper with the tool or attempt to use it for
GEA010-1
other than driving staples.
9. Do not operate the tool without staples. It
shortens the service life of the tool.
10. Stop driving operations immediately if you notice
something wrong or out of the ordinary with the
tool.
11. Never staple into any materials which may allow
the staple to puncture and fly through as a
projectile.
12. Never actuate the switch trigger and safety lever
at the same time until you are prepared to staple
workpieces. Allow the workpiece to depress the
safety lever. Never defeat its purpose by securing
ENB069-1
the safety lever back or by depressing it by hand.
13. Never tamper with the safety lever. Check the
safety lever frequently for proper operations.
SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
13. Screw
14. Material
15. View window
16. Pusher
BST110
10 mm
7 mm - 10 mm
125 pcs
245 mm x 79 mm x 191 mm
2.0 kg
D.C. 14.4V
ENC007-4