Beko HIXI 84700 UF Installationsanleitung Seite 18

cut injuries. Therefore always wear
protective gloves during transport and
installation.
•
Disconnect electrical connections in the
area of installation before starting the
installation.
• Surfaces of the furniture that the
appliance shall be installed shall be heat
resistant (100 °C minimum).
• Make sure that the furniture is in
straight, horizontal position and that
it is fixed before the installation of the
appliance.
•
Do not install heat insulation strips to
the furniture that the appliance shall be
installed.
•
The air to be expelled from the product
should not be fed into a chimney
used by other appliances burning
gas or other fuels. (not applicable for
appliances that discharge air back into
the room).
•
Legislation regarding the evacuation of
air must be complied with.
•
Poisoning Danger! While the appliance
is operating, air is drawn from the
whole house. If adequate ventilation
is not provided, air flow occurs and
the waste and toxic gases released
as a result of combustion in the house
are reabsorbed. Do not operate the
product together with products that
provide air circulation and may emit
toxic gas (wood, gas, oil and coal
stoves, boilers, water heaters, etc.).
•
Have the adequacy of your building's
ventilation and chimney system
checked by authorized persons.
•
If there is another appliance operating
with energy other than electrical
energy in the same environment with
ventilation, the negative pressure in the
room should be at most 0.04 mbar so
that the exhaust of the other appliance
is not drawn back into the room by the
ventilation.
•
Dimensions given in installation
diagrams are in mm.
•
The air to be expelled from the
ventilation should not be fed into a
chimney used by other appliances
burning gas or other fuels. (not
applicable for appliances that discharge
air back into the room).
18
•
Legislation regarding the evacuation of
air must be complied with.
•
Oil sludges may form on metal oil
filters. For that reason, there should
not be any flame near the product.
In addition, installation of the product
near a heating equipment using solid
fuel is only permitted if there is a non-
removable closed cover to prevent
sparks.
•
Our company shall not be responsible
for problems that arise for not observing
any of the warnings above.
•
The product manufacturer does not
accept any responsibility for the defects
caused by the ventilation pipes used in
the installation.
•
The air outlet pipe to be used should
be as short as possible, straight and
should have a large diameter.
•
Long air outlet pipes, multiple pipe
bends or small pipe diameters reduce
ventilation performance and increase
fan noise.
•
The air outlet pipe must be made of
non-combustible material.
•
The air outlet pipe should be installed
with an inclination of 1 degree to
prevent the return of condensation.
Product dimensions (Figure 1)
Pay attention to the product dimensions.
Consider its suitability with your furniture.
Your product is suitable for 3 different types
of installation according to the suitability of
your furniture. A, B and C type installations
are described respectively.
A : Installation without internal circulation
shaft
B : Installation with internal circulation shaft
C : Installation with external circulation
A type installation (Installation
without internal circulation
shaft)
Preparation of the furniture on which
installation will be made: (Figure A2)
Prepare your furniture according to the
dimensions presented in Figure A2. Cut
dimensions for flush-fit installation are also
indicated in Figure A2.