Herunterladen Diese Seite drucken

Beko HIXI 84700 UF Installationsanleitung Seite 19

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21
Steps for A type installation
Remove the tape on the countertop
plastic described in Figure A3, and
place it in its slot on the back of the hob
as shown in the figure.
Completely remove the drawers of your
furniture and place your stove in its
place on your furniture. (Figure A4)
Stick the countertop plastic on the wall
by pulling it towards the wall through
the gap you have opened in your
furniture. (Figure A5)
Put your drawers back in place. (Figure
A6)
Remove the metal oil filter by pulling it
upwards. (Figure A7)
Remove the liquid collection chamber
as shown in the figure A7.
Place two units of active carbon filters
to right and left as shown in figure A8.
Place back the liquid collection
chamber as shown in the figure A9.
Complete the installation by placing
back the metal oil filter.
B type installation (Installation
with internal circulation shaft)
Preparation of the furniture on which
installation will be made: (Figure B2)
Prepare your furniture according to the
dimensions presented in Figure B2. Cut
dimensions for flush-fit installation are also
indicated in Figure B2. You need to obtain
the plastic parts of the air guide described in
this installation from the authorized service
or authorized dealers. These parts are not
supplied with the product.
Steps for B type installation
Place the ventilation corner plastic
described in Figure B3 in its slot on the
back of the hob as shown in the figure.
Completely remove the drawers of your
furniture and place your stove by tilting
it into its place on your furniture. (Figure
A4)
Attach the long and corner plastics
of ventilation that will direct the air to
the bottom of the furniture, and attach
them to the corner plastic you have
attached to the back of the stove as
shown in figure B5. In order to attach it
to the corner plastic, you need to lift the
hob a little from the back. Ventilation
plastic parts must have been mounted
as shown in figure B6.
Attach the ventilation outlet bit to the
ventilation corner plastic from the
bottom of your furniture as shown in
figure B7.
Put your drawers back in place. (Figure
B8)
Remove the metal oil filter by pulling it
upwards. (Figure B9)
Remove the liquid collection chamber
as shown in figure B9.
Place two units of active carbon filters
to right and left as shown in figure B10.
Place back the liquid collection
chamber as shown in figure B11.
Complete the installation by placing
back the metal oil filter.
C type installation (Installation
with external circulation)
Preparation of the furniture on which
installation will be made: (Figure C2)
Prepare your furniture according to the
dimensions presented in Figure C2. Cut
dimensions for flush-fit installation are also
indicated in Figure C2. You need to obtain
the plastic parts of the air guide described in
this installation from the authorized service
or authorized dealers. These parts are not
supplied with the product.
Steps for C type installation
Place the ventilation corner plastic
described in Figure C3 in its slot on the
back of the hob as shown in the figure.
Completely remove the drawers of your
furniture and place your stove by tilting
it into its place on your furniture. (Figure
C4)
Attach the long and corner plastics
of ventilation that will direct the air to
the bottom of the furniture, and attach
them to the corner plastic you have
attached to the back of the stove as
shown in figure C5. In order to attach it
to the corner plastic, you need to lift the
hob a little from the back. Ventilation
plastic parts must have been mounted
as shown in figure C5.
Reach at your chimney using ventilation
parts in accordance with its location.
19

Werbung

loading

Diese Anleitung auch für:

Gieh 834480 pGieh 634480 p