S&P TD EVO ECOWATT-Serie Bedienungsanleitung Seite 12

ENGLISH
EN
This instruction manual contains important in-
formation and must be read carefully by com-
petent persons prior to any handling, trans-
port, inspection or installation of this product.
Every care has been taken in the preparation
of the instructions and information; however,
it is the responsibility of the installer to ensu-
re the system complies with relevant national
and international regulations, especially safe-
ty. The manufacturer, Soler & Palau Sistemas
de Ventilación S.L.U. accepts no responsibility
for breakages, accidents or any inconvenience
caused by failure to comply with the instruc-
tions contained in this manual.
The fans referred to in this manual have been
manufactured in accordance with rigorous
quality control and International standard ISO
9001. Once the product has been installed, this
manual to be retained by the end user.
WARNINGS
Any work including transport, installation,
inspection, maintenance, service spares re-
placement, repair and fi nal end of life dispos-
al must be carried out by competent persons
and supervised by competent executive.
Fan equipment should be electrically isolated
and locked out before any work started.
This fan must not be used in hazardous area.
The Installer, User is responsible for ensuring
that the fan is installed, operated and serviced
by qualifi ed personnel, acting in accordance
with all safety precautions applicable and as
required by law, regulations and standards in
the country applicable.
Safety protective clothing, equipment, hearing
protection, and tools may be required.
All fans are designed and manufactured in ac-
cordance with EC Directive. Safety guard ac-
cessories are available from S&P if required
due to specifi c installation.
This instruction manual is subject to modifi ca-
tions due to further technical developments of
the fan described, images and drawings may
be simplifi ed representations. Due to improve-
12
ments and modifi cations the fan operated may
differ from the representations. We reserve the
right to vary the product without prior notice.
Working ambient temperature for fan equipment
should not be exceeded, typically this will be
within -20°C to +40°C, unless stated otherwise.
Allow safe access to fan for inspection, mainte-
nance, replacement of parts, cleaning / house-
keeping.
The user is responsible for effective mainte-
nance, replacement of parts, cleaning, espe-
cially where dust may form inside the fan.
Do not remove safety protection guards or
open access doors when the fan is in operation.
If the fan is used in atmospheres with more
than 95% Relative Humidity (RH), consult the
S&P Technical Service fi rst.
Precautions must be taken to avoid the back-
fl ow of gases into the room from the open fl ue
of gas or other fuel-burning appliances.
The following risks have been identifi ed for
consideration:
• Installation: incorrect installation or function
represents a risk to safety.
• Rotational speed: identifi ed on fan name
plate and motor. Never exceed this speed.
• Rotation of impeller: identifi ed on fan with di-
rection arrows. Do not run impeller in reverse.
• Working temperature: identifi ed on fan name-
plate and motor. Never exceed this range.
• Foreign bodies: ensure no risk from debris, or
material that could be drawn into fan.
• Electrical risks: motor name plate data
should never be exceeded, effective connec-
tion to earth, and all checked regularly every
6 months.
• Protection devices: These should always be
operational and never disconnected.
• Means for disconnection must be incorporat-
ed in the fi xed wiring according with the wir-
ing rules. An external disconnecting device,
which will function as the "designated" dis-
connect device must be provided, and:
1) It shall disconnect the "Line", while dis-
connection of the "Neutral" is optional;