Protecting The Environment - DeWalt DCS777 Originalanweisungen

EnGLIsh

WARNING: To reduce the risk of serious personal injury, turn
machine off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: If the saw blade is worn replace it with a new sharp blade.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Before use, carefully check the upper blade guard, movable lower blade
guard as well as the dust extraction tube to determine that it will operate
properly. Ensure that chips, dust or workpiece particle cannot lead to
blockage of one of the functions.
In case of workpiece fragments jammed between saw blade and guards
disconnect the machine from the power supply and follow the instructions
given in section Mounting the saw blade. Remove the jammed parts and
reassembling the saw blade.

WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.

WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.

WARNING: To reduce the risk of injury, regularly clean the
table top.

WARNING: To reduce the risk of injury, regularly clean the dust
collection system.
Optional Accessories

WARNING: Since accessories, other than those offered by D
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with this product.
Range of saw blades available (recommended
blades)
Type of blade Blade dimensions
(diameter x bore x no. of teeth)
DT4310 series 40 216x30x24
DT4286 series 40 216x30x80
DT4320 series 60 216x30x48
DT4350 series 60 216x30x60
DT99568-QZ 216x30x24
DT99569-QZ 216x30x36
DT99570-QZ 216x30x60
Consult your dealer for further information on the appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal household waste.
36
WALT,
e
WALT,
e
Usage
For general purpose, ripping and cross-
cutting of wood and plastics
TCG for use with aluminum
ATB for fine cutting of manmade and natural
wood
TCG for extra fine cutting of manmade and
natural wood
24T Flexvolt blade for general purpose,
ripping and cross cutting
36T Flexvolt blade for fine cutting
60T Flexvolt blade for ultra-fine cutting
Products and batteries contain materials that can be recovered or recycled
reducing the demand for raw materials. Please recycle electrical products
and batteries according to local provisions. Further information is available
at www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end of its
technical life, discard it with due care for our environment:
• Run the battery pack down completely, then remove it from the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a local recycling
station. The collected battery packs will be recycled or disposed
of properly.