Declaration Of Conformity; Battery Charging - Bosch GST Professional 14,4 V Originalbetriebsanleitung

OBJ_BUCH-624-003.book Page 21 Tuesday, October 20, 2009 11:37 AM
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
05.10.2009
Assembly
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.

Battery Charging

A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cy-
cles.
To remove the battery 3 press the unlocking but-
tons 4 and pull out the battery downwards. Do
not exert any force.
Bosch Power Tools
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Replacing/Inserting the Saw Blade
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Insert the saw blade 12 (teeth in cutting direc-
tion) into the stroke rod until it latches 9.
While inserting the saw blade, pay attention that
the back of the saw blade is positioned in the
groove of the guide roller 10.
9
10
Note: If the grooves of the saw blade holder are
not in the position shown in the figure, then the
saw blade 12 cannot be inserted into the stroke
rod 9. Briefly press the SDS clamping lever 8 to-
ward the side and release it again.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to inju-
ries.
2 609 932 701 | (20.10.09)
English | 21