Unpacking The Appliance; General Notes On Use; Functionality Of The Device; Electrical Connection - Clatronic KM 3646 Bedienungsanleitung

Unpacking the Appliance

WARNING: Risk of injury!
Some parts of the accessory are very sharp!
1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic film, filler
material, cable ties and box packaging. Keep the blade
guard of the dicing cutter for appropriate storage.
3. Check that all parts are in the box.
4. If the packaging content should be incomplete or if dam-
ages should be noticeable, do not operate the appliance.
Return it to the distributor immediately.
NOTE:
Dust or production residues may still be found on the
appliance. We recommend that you clean the appliance as
described under "Cleaning".

General Notes on Use

Functionality of the device

• The appliance is equipped with safety switches. The appli-
ance can only be operated if you observe the following:
- When fitting onto the motor housing, the working bowl
or the blender jug with the knife block must audibly
click into place.
- When using the bowl, either the lid must audibly click
into place onto the bowl.
• Turn the control knob to select the speed. Always start
slowly with a low speed.
• PULSE = Pulse mode: Hold the control knob in this posi-
tion to run the appliance at the maximum speed setting.
• 0 is the off position.
CAUTION:
• Always set the control knob to 0 before plugging in.

Table of Use of the Accessories

Product / Type of preparation
Mix food with liquids
Nuts
Herbs
Chocolate (cut into pieces)
Cut meat into pieces
Chop onions, carrots, potatoes, cucum-
ber
Shred or cut onions, carrots, potatoes,
cucumber
KM3646_IM
CAUTION:
• Short-term operation with the bowl: With heavy
dough do not operate the appliance longer than 1
minute and leave for 2 minutes to cool down.
• Short-time operation mixer: Do not use the appliance
longer than 3 minutes continuously. Allow to cool down
for 1 minute before using it again.
• Disconnect the plug from the socket after use.

Electrical Connection

Ensure that your mains power corresponds with the specifi-
cations on the type label.

Assembly of the Working Bowl and the Accessories

WARNING:
The grating and cutting blade, and the dicing blade are
very sharp on the cutting and grating surfaces! Therefore
use these accessories with the necessary care to prevent
injuries.
1. Place the guide pin onto the drive shaft of the motor
housing.
2.
NOTE:
The bowl has a mark at the bottom. The symbols
and can be found on the motor housing.
Align the bowl marking with the
towards . It latches into place.
3. Select an attachment. Place it onto the guide pin.
NOTE grating and cutting blade:
The grating and cutting blade can be placed on both
sides. The desired cutting surface must point upwards.
4. Close the working bowl with the lid. Put the lid on, so
that the lock symbols of the lid are found to the left of the
handle. Tighten the lid counterclockwise.
Amount Tool
Max. 1500 ml Blender jug
Min. 200 g Working bowl with dicing
Max. 500 g blade
Working bowl with dicing
Max. 1000 ml
blade
Working bowl with dicing
Max. 200 g
blade
Working bowl with dicing
Max. 500 g
blade
Working bowl with dicing
Max. 500 g
blade
Max. 1000 ml Rasp / cutting blade

Using the Working Bowl

symbol. Turn the bowl
Level Max. Operating time
1 - 2 3 minutes
2 2 minutes
2 3 minutes
2 1 minute
2 2 minutes
2 1 minute
2 3 minutes
02.06.16
47