JESS Welding conMIG 300 Betriebsanleitung Seite 47

11 Welding torch with display
11 Welding torch with display
NOTICE
• Only replace the torch when the machine is switched off!
Tab. 5 Functions sorted by control box
Hnd
■
MC 3
MC 4 ■
■*
MC 5
1
Functions with extended selection
MODE function (Mod)
Mode: 2-step/4-step/spot
• Display: 'Mod'
• Use the '−' button to switch between 2-step (2) and 4-step (4) mode (left-hand display shows 2 or 4)
• Use the '+' button to switch between normal operation (−) and spot welding (S) (right-hand display
Mode: automatic or manual welding
• Display: 'Mod'
• Press and hold the '−' button to switch between automatic (A) and manual (H) mode (middle display
Job function (MC 3 only)
Access a single job
• Repeatedly press the arrow button until 'Job' appears on the display
• Press the + or − button to select the desired job number and the arrow button to confirm
• The job, e.g. no. 2, is selected (= appears on the display)
Note: = – job selected, u – job number used, F – job number free
Saving and accessing several jobs in a row
It is possible to save several jobs one after another so as to switch between the individual jobs during the
welding process. This is useful if, for example, a component has to be welded using different levels of
welding power but the welding process must not be interrupted.
NOTICE
The jobs must all have the same wire diameter and gas type.
• It is, however, possible to use e.g. standard MIG/MAG and adjust the power setting.
• The job sequence must always be delimited with a free job at the start and end.
EN - 18
Cor Mod Sts
■* ■ ■
■* ■ ■
■ ■
* This function is active during welding
Hnd
Cor
Mod
Sts
bUb
PrG
PoG
Job
Spt
shows − or S)
shows A or H)
bUb PrG PoG
■ ■ ■
■
■
Manual mode
Wire feed correction (automatic mode)
 Mode (see MODE function (Mod))
Start speed
Burn back
Gas pre-flow time
Gas post-flow time
 See Job function (MC 3 only)
Spot time
conMIG 300
Job Spt
■ ■
■
■
BA-0001 • 2020-12-01