JESS Welding conMIG 300 Betriebsanleitung Seite 41

8 Operation
8.1.3 MC 5 control system
Fig. 6
,
A
B
Pos.
A
B
C
D
E
F
G
H
I
EN - 12
MC 5 control box
Display for current (A) or C
voltage (V) D
E
LED indicator of the parameter
F
shown on the display (A)
I
H
G
F
Description
Display for the welding current in amperes or the welding voltage in volts as well as the creep
speed and wire burn-back time.
LED indicator of the parameter that is currently shown on the display (A) (creep speed, wire
burn-back time or welding current).
Operating button for selecting the creep speed, wire burn-back time, material thickness and
welding current (spot time if spot welding is activated).
Operating button for activating the gas test. In setup mode, operating button for increasing
the creep speed and wire burn-back time (LED pos. B) flashes.
Operating button for activating the wire feed function. In setup mode, operating button for
lowering the creep speed and wire burn-back time (LED pos. C) flashes.
Knob for setting the wire speed in m/min.
LED indicator for the active welding type: 2-step, 4-step, 2-step spot.
Operating button for selecting the welding type: 2-step, 4-step, 2-step spot.
Display of the wire speed in m/min. Flashing dot: HOLD function active.
Parameter selection switch G LED indicator for the active
Gas test / increase parameter
H Welding type selector
Wire feed / decrease parameter
I
Knob for the wire speed
conMIG 300
welding type
Wire feed speed display
A
B
C
D
E
BA-0001 • 2020-12-01