JESS Welding conMIG 300 Betriebsanleitung Seite 40

conMIG 300
Pos.
L
M
N
8.1.2 MC 4 control system
Fig. 5
A
B
C
D
Pos.
A
B
C
D
E
F
G
H
I
J
K
L
BA-0001 • 2020-12-01
Description
Operating button for selecting the welding type: 2-step, 4-step, 2-step spot or custom function.
LED indicator for the active welding type: 2-step, 4-step, 2-step spot or custom function.
Display for wire speed in m/min and wire speed adjustment by −50% to +50%. Flashing dot:
HOLD function active.
MC 4 control box
Voltage display (V) E
Current display (A) F
LED indicator of the parameter G Manual/automatic mode indicator
shown in the display (B) H Material selection /
Parameter selection switch
L
K
J
I
H
G
Description
Display for the welding voltage in volts. Flashing dot: HOLD function active and welding
voltage step on step-controlled machines.
Display for the welding current in amperes or the material thickness as well as the creep
speed and wire burn-back time.
LED indicator of the parameter that is currently shown on the display (B) (creep speed, wire
burn-back time or welding current).
Operating button for selecting the creep speed, wire burn-back time, material thickness and
welding current (spot time if spot welding is activated).
Operating button for activating the gas test. In setup mode, operating button for increasing
the creep speed and wire burn-back time (LED pos. C) flashes.
Operating button for activating the wire feed function. In setup mode, operating button for
lowering the creep speed and wire burn-back time (LED pos. C) flashes.
LED indicator for indicating manual or automatic mode.
Operating button for material selection (tap for less than 0.5 seconds) and selecting
manual/automatic mode (press for more than 1 second).
Knob for setting the material type, wire speed and other parameters.
Operating button for selecting the welding type: 2-step, 4-step, 2-step spot.
LED indicator for the active welding type: 2-step, 4-step, 2-step spot.
Display for wire speed in m/min and wire speed adjustment by −50% to +50%. Flashing dot:
HOLD function active.
Gas test / increase parameter
Wire feed / decrease parameter
manual/automatic mode selection
8 Operation
I Knob for parameter settings
J Welding type selector
K LED indicator for the active
welding type
L Wire feed speed display
A
B
C
D
E
F
EN - 11