JESS Welding conMIG 300 Betriebsanleitung Seite 42

conMIG 300
8.1.4 MC 15 control system
Fig. 7
A
B
Pos.
A
B
C
D
E
F
BA-0001 • 2020-12-01
MC 15 control box
Knob for setting the creep speed
Knob for setting the wire burn-back
F
E
D
C
Description
Operating button for setting the creep speed (start speed). Press the button and use the knob
(pos. D) to set the desired value. Setting range: 10–100% of the welding speed.
Operating button for setting the wire burn-back time (wire length at the end of welding). Press
the button and use the knob (pos. D) to set the desired value. Setting range −10 (long wire
end) to +10 (short wire end).
Operating button for selecting the welding type: 2-step or 4-step. The relevant LED illuminates.
Knob for setting the wire speed, creep speed and wire burn-back time.
Operating button for activating the wire feed function. The wire is fed in for as long as the
button is pressed.
Display for the wire speed, creep speed and wire burn-back time. The welding current is
displayed during the welding process and when the HOLD function is active (15 sec).
C Welding type selector
D Knob for parameter settings
8 Operation
E Wire feed
F Parameter display
A
B
EN - 13