Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Make sure that the power cable or extension cord can not be
accidentally pulled out of the socket during operation.
Use the handle to carry the appliance.
Warning: To prevent overheating, do not cover the fan.
DANGER FOR CHILDREN: Children must not play with the packaging
USE
The fan has 3 speeds, its rotating head ensures smooth rotation. It is quiet, with a low energy consumption,
reliable and safe and at the same time, ensures effective air circulation.
0 - Fan is off.
1 - Fan is running at low speed.
2 - Fan is running at medium speed.
3 - Fan is running at high speed.
•
The fan can rotate during operation.
•
For the fan head to rotate, push the automatic rotation control down.
•
To stop the rotation of the fan head, pull the automatic rotation control up.
•
The fan head can be set up or down. Loosen the vertical setting nut, adjust the desired angle of the fan
and tighten the nut again.
INSTALLATION
1.
Place the stand "15A" on the stand "15B" and make a base in the X shape.
2. Place the bottom tube flange (14) on the X shaped base and attach it with the four supplied screws.
3. Slide the base plastic cover (16) down the bottom tube onto the base. Slide the upper (inner) tube (12) to
the desired height and tighten using the connecting part (13) clockwise.
4. Fit the body (10) including the motor to the upper tube (12). Ensure that the body is fully pushed on the
tube and secure it with the locking screw (11).
5.
Unscrew the rear grille attachment nut (4) by turning it counterclockwise.
6. Place the rear grille (5) against the motor cover (7) with the handle up. Make sure the guide pins of the
motor cover are properly inserted into the grille holes.
7.
Screw the nut for attaching the back grille (4) firmly by turning it clockwise.
8. Remove the plastic protector from the motor shaft (6).
9.
Insert the propeller (3) onto the motor shaft (6) by gently sliding it onto the motor shaft guide pin and
securing it with the central nut (2).
10. Attach the front grille (1) to the rear grille (5) so that the screw holes in the bottom of the grille frames fit.
11. Turn the clamps in the grille frames and join the grilles firmly together. Screw the grilles together.
CLEANING AND MAINTENANCE
1.
Before cleaning pull out the plug of the power cord from the outlet!
2. Wipe the surface of the fan with a clean and dry cloth. If the fan is very dirty, it can be dismantled and
the individual parts (except the power cable) can be treated with a cloth or sponge slightly moistened
detergent solution. Then wipe dry thoroughly all parts. Make sure that no water gets into the motor
during cleaning.
3. When dismantling the fan, proceed in reverse order of the assembly.
4. Make sure no liquid can enter the motor.
Do not immerse in water!
material. Do not let children play with the
plastic bags. Risk of suffocation.
5
Werbung
Inhaltsverzeichnis
