Herunterladen Inhalt Inhalt Diese Seite drucken

Operation - ATIKA LC170F Originalbetriebsanleitung

Benzinmotor
Vorschau ausblenden Andere Handbücher für LC170F:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Make sure before beginning with your check that the engine is
placed on level ground and the ignition switch is set to OFF.
Inspect the general condition of the engine
Check to see whether any traces of oil or gasoline leaks are
present around or underneath the engine.
Remove coarse dirt buildup especially in the area of silencer
and cranking rope.
Check for any possible damages.
Check whether all protective covers are properly installed and
all screws and nuts are firmly tightened.
Inspect the engine
Check the oil level of the engine. The engine may sustain damage
when running with the oil level too low.
Check the oil level before each start to avoid unexpected downtimes.
Check the air filter. A soiled air filter reduces the air supply to the
carburettor and thus the engine power.
Check the gasoline level. Starting the engine with a full tank avoids
or reduces standstill times for fuelling.
Inspect the machine powered by the motor
Before starting the engine read the operating instructions for the
machine powered by this engine, and follow the directions and safety
precautions contained in them.

5. OPERATION

SAFETY ADVICES
Before starting the engine for the first time please read the
IMPORTANT SAFETY ADVICES and the chapter with the title
CHECKS BEFORE STARTING.
Carbon monoxide is toxic.
Inhaling it may cause unconsciousness that may lead to death.
Avoid areas and activities where you are exposed to carbon
monoxide gases.
Read the instructions for the machine powered by the engine and
follow the safety instructions in regard to starting, stopping and
operating the engine.
STARTING THE ENGINE
1.
Set the fuel valve to ON.
CHECKS BEFORE STARTING / OPERATION
FUEL VALVE
ON
2.
To start the engine while it is cold, move the choke lever to
the "CLOSED" position.
To start the engine while it is warm, move the choke lever to
the "OPEN" position.
CHOKE LEVER
CLOSED
3.
Turn the throttle lever from the SLOW position by approx.
1/3 toward FAST.
THROTTLE
FAST
4.
Set the ignition switch to ON.
OPEN
SLOW
SLOW
IGNITION SWITCH
OFF
ON
18

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis