Troubleshooting - Parkside PWH 2800 A1 Originalbetriebsanleitung

GB IE

Troubleshooting

Problem
Motor not running
Garden waste not
being pulled in
Shredded material
hangs together in a
chain
34
Possible cause
Collection box (11) not
in correct position
Overload protection
No mains power supply
Safety switch (10) on
the collection box (11)
not engaged
Cutting roll is in reverse
Shredding material too
soft
Cutting roll is blocked
Pressure plate not cor-
rectly inserted
Troubleshooting
Insert the collection box
(11) correctly and move the
safety switch (10) on the
collection box (11) as far
up as it will go so that only the
green "ON" field is visible (see sec-
tion "Assembly instructions/assem-
bling the device").
To switch on again, turn the rotary
switch (2) to the "OFF" position. Press
the reset button (1). Turn the device on
again (see section "Operation/restart
lock").
Check the socket, cable, line, plug,
and have them repaired by a quali-
fied electrician if necessary
Push the safety switch (10)
on the collection box (11)
up as far as it will go so
that only the green "ON" field is vi-
sible (see section "Assembly instruc-
tions/assembling the device")
Change the rotational direction (see
section "Operation").
Push through using wood or shred
dry branches
Release blockage (see section
"Operation/release blockage")
Adjust the pressure plate (see sec-
tion "Operating instructions/adjus-
ting the pressure plate")