Closing The Door; Installation - Electrolux SG181N Benutzerhandbuch

Problem
There is too
much frost.
The buzzer
sounds. The
Alarm icon flash-
ing.
dEMo appears
on the display.
upper or lower
square is shown
in the tempera-
ture display.

7.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
The product temperature is
too high.
Many products are stored at
the same time.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed cor-
rectly.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The appliance is in demon-
stration mode.
An error has occurred in
measuring the temperature.
Solution
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Store products so that there
is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Refer to "Door open alarm".
Keep pressed approximately
10 sec the OK button since a
long sound of buzzer is heard
and the display shut off for a
short while: appliance start
works regularly.
Call your service representa-
tive (the cooling system will
continue to keep food prod-
ucts cold, but temperature
adjustment will not be possi-
ble).
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
ENGLISH 11