Ryobi RLT30CD Bedienungsanleitung Seite 15

GB
F D E I
DESCRIPTION
1. Primer Bulb
2. Choke Dail
3. Fuel Cap
4. Starter Grip
5. Throttle Lock
6. On / Off Switch
7. Throttle Trigger
8. Rear Handle
9. Front Handle
10. Shaft
11. Grass Deflector
TM
12. Pro Cut ll
13. Cutting Line
14. Idle Speed Screw
TM
15. Reel Easy
16. Knob
17. Hanger Cap
ASSEMBLY
Please refer to Fig. 2.
WARNING
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in
serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
OPERATION
Read the operation manual and follow all
warnings and safety instructions.
Wear eye, hearing, and head protection.
Keep all bystanders, especially children and
pets, at least 15 m from the operating area.
All manuals and user guides at all-guides.com
P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT
English
FUEL AND REFUELING
HANDLING THE FUEL SAFELY
Always handle fuel with care, it is highly flammable.
■
Always refuel outdoors where there are no sparks
■
and flames. Do not inhale fuel vapors.
Do not let petrol or lubricant come in contact with your
■
skin.
Keep petrol and lubricant away from the eyes. If
■
petrol or lubricant comes in contact with the eyes,
wash them immediately with clean water. If irritation is
still present, see a doctor immediately.
Clean up spilled petrol immediately.
■
MIXING THE FUEL
This product is powered by a 2-stroke engine and
■
requires pre-mixing petrol and 2-stroke lubricant. Pre-
mix unleaded petrol and 2-stroke engine lubricant in a
clean container approved for petrol.
This engine is certified to operate on unleaded petrol
■
intended for automotive use with an octane rating
of 87 ([R + M] / 2) or higher.
Do not use any type of pre-mixed petrol / lubricant from
■
fuel service stations, this includes the pre-mixed petrol
/ lubricant intended for use in mopeds, motorcycles,
etc.
Use synthetic 2-stroke lubricant only. Do not use
■
automotive lubricant or 2-stroke outboard lubricant.
Mix 2% synthetic 2-stroke lubricant into the petrol.
■
This is a 50:1 ratio.
Mix the fuel thoroughly and also each time before
■
fueling.
Mix in small quantities. Do not mix quantities larger
■
than usable in a 30 day period. Synthetic 2-stroke
lubricant containing a fuel stabilizer is recommended.
FILLING THE TANK
Clean surface around fuel cap to prevent
■
contamination.
Loosen fuel cap slowly to release pressure and to
■
keep fuel from escaping around the cap.
Carefully pour fuel mixture into the tank. Avoid spillage.
■
Prior to replacing the fuel cap, clean and inspect
■
the gasket.
12 12
LV
(Fig. 3)
SK BG