Plant Assembly; Choosing Assembly Site - tom logisch aquonic Benutzerhandbuch

aquonic | User Manual
FULLY AUTOMATED WATER TREATMENT PLANT FOR YACHTS AND HOUSEBOATS

Plant assembly

CHOOSING ASSEMBLY SITE

The plant should be installed low and as close to the
inlet valve as possible to ensure an unobstructed sup-
ply of water. Furthermore, the prefilter and inlet vale
1
2
Inlet valve, we recommend TRUDESIGN plastic
1
valves with ¾" ID (separatly deliverable; not
within scope of delivery)
2
Sediment-prefilter (within scope of delivery)
3
Prepump (within scope of delivery)
4
Onboard fresh water tank; we recommend a
capacity of at least 200L (separatly deliverable;
not within scope of delivery)
The plant is not frost-proof and must therefore be installed in a frostproof
place oft he vessel or vehicle. If there is no appropriate place, the plant must
be equipped with an extra heating system or be shut down and winterized
during winter. Please refer to chapter SHUT DOWN for further information.
34
3
6
should be close to the plant. If the plant cannot be in-
stalled below the water level, the prepump must be
placed next to the inlet valve.
Tap water tank or drainage; we recommend a
5
capacity of at least 200L with overflow or 10 mm
ID drainage (separatly deliverable; not within
scope of delivery)
6
Flushing water inlet from the vessel's water
supply (around 2-3 bar high pressure line
required, branch off from cold water tap or water
pressure pump ; installation material separatly
deliverable; not within scope of delivery)
4
5