Water Connection; Electrical Connection - Edesa LP 55-65 Bedienungsanleitungen

Ensure that the mains pressure is not below 0.2 MPa (2 Bar) and not above 0,5 MPa (5 Bar).
The appliances are all fitted with an extra pump to increase pressure. If the calcium and magnesium salt content
in the water is high, it is advisable to install a softener.
Where recommended, the resins of the softener should be regenerated weekly by introducing coarse cooking
salt.
Every appliance comes with a water inlet rubber hose with 3/4"fitting, which should be connected to the mains
water supply.
The water temperature at the inlet should be between
Push the drain or outlet hose firmly onto the union elbow situated beneath the appliance. This hose, 2m. long
with outer dia. of 38 mm., is also supplied with the appliance.
Electrical connection must be in compliance with the standards and regulations in force.
Make sure the appliance is connected to an efficient earthing system and that the line voltage corresponds to
that indicated on the appliance rating plate.
Connect the power supply cable to a wall-mounted differential magnetothermal switch with a contact separation
of at least 3 mm.
There is a terminal marked
different appliances.
Every appliance comes with an adequate power supply cable.
MODEL
LP 55-65/80
LP 65-65
LP 125-80
MACHINE INSTALLATION(for the installer)

WATER CONNECTION

ELECTRICAL CONNECTION

at the rear of the machine, which allows equipotential connection between
ELECTRICAL INPUT
230V3~
400V3N~
400V3N~
400V3N~
15°C and 35 º C.max: LP55-65/80 – LP65-65
40°C and 55 º C.max: LP125-80
TOT. POWER MAX
(W)
7500
7500
11300
14000
ELECTRICAL
ASSORPTION MAX
(A)
27
13
20
21
14