Filling Ground Coffee Compartment; Adjusting Grinder Setting; Water Filter; Before First Use - Zelmer ZCM8121 MAESTRO BARISTA Benutzerhandbuch

1.4. Filling ground coffee compartment

1. Open ground coffee compartment lid (12) and pour the desired quan-
tity of ground coffee inside
Important: take into account that only one coffee at a time can be pre-
pared.
Do not use instant coffee!
Do not fill beyond the upper edge of the compartment!
2. Close the lid.

1.5. Adjusting grinder setting

Due to the different roasting degrees, blends, brands, etc., grind setting can be adjusted to suit
your preference.
1. Use the rotary selector (14) to adjust the grind setting.
elector can be adjusted from fine to coarse
2. Set the selector to the corresponding position by lining it up with the
index on the container.
NOTES:
- Adjust the grind setting only while the grinder is working, otherwise it might be dama-
ged.
- The new setting will not be noticed until after the second cup of coffee.
- Do not insert fingers or foreign objects into the grinding unit!

1.6. Water filter

The water filter (15) is supplied as an accessory (model dependent). It may be purchased from our
after-sales service or specialist shops (see section "Accessories"). The filter is recommended for:
- Protection against scaling (increase of appliance lifetime, decalcification with chemicals not ne-
cessary).
- Reduction of toxic heavy metals (copper, lead).
- Reduction of harmful organic substances (pesticides, herbicides).
- Reduction of unwanted odour and taste (chlorine).
- Optimization of coffee taste and crema.
42
.
To assemble the filter, proceed as follows:
1. Rinse the new filter in a water container.
2. Firmly insert the filter into the water tank con-
nection in an upright position.
Very important: make sure that the rubber gas-
ket is correctly inserted in the coupling on the
bottom of the water tank
3. It is recommended to replace the filter every 2 months.
Replacement should be carried out preferably just after having carried
out a descaling process. Turn date indicator on the top of the filter to
show the replacement month on the left side of the window. On the right
side it is shown the month when the filter should be replaced.
4. Program the coffee maker to indicate that the filter is mounted (see section "Activating water filter").
5. Then, dispense a cup of hot water to rinse water circuit.

2. BEFORE FIRST USE

1. Remove the water tank (6). Take it from the handle (7) and pull it
out.
2. Wash the water tank under the tap.
3. Fill the water tank. Never fill beyond the level for maximum filling
(MAX)!
43