Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Insert the water tank into the coffee maker. Make sure it is fitted co-
rrectly.
5. Plug the coffee maker to the mains.
6. Place a container underneath the coffee and steam outlet nozzles.
Height of coffee outlet nozzles can be adjusted moving them upwards
and downwards.
7. Touch the icon
to switch the coffee maker on. Rinsing process will
start automatically .
8. Indicators of the icons will light up and go
off alternatively.
After a time, water will start flowing out throu-
gh the nozzles.
9. Once the rinsing process has finished , all
the indicators will light up permanently.
10. Remove the container placed underneath the nozzles and empty it. Never drink water collec-
ted after rinsing process!
11. After rinsing, the coffee maker is ready to be used.
Notes:
- Automatic rinsing process will be carried out each time the coffee maker is plugged in to the mains, or
when the coffee maker has cooled down after having prepared a drink. Duration may vary depending
on the temperature of the system. Starting from cold, duration is about 45 seconds.
- The coffee maker is tested at the factory using coffee and water. Although the unit has been carefully
cleaned, it is possible that some water and coffee residues remain. It is recommended to carry out this
rinsing process several times before first use.
44
3. SETTING UP THE COFFEE MAKER
3.1. Selecting the temperature
Coffee temperature can be adjusted to suit your preference. While the
coffee maker is plugged in, proceed as indicated below:
1. If the coffee maker is switched on, touch the icon
to switch it off.
All the indicators will go off.
2. Touch the icon
for 3 seconds. A beep will
be heard and the indicator will light up showing pre-
selected temperature level. Indicator of the icon
will flash
3. Touch the icon
repeatedly for changing water temperature. Indicators will light up suc-
cessively with each touch.
MINIMUM
4. Touch the icon
to confirm your choice.
All the indicators will go off again.
3.2. Selecting water hardness
Water hardness can be selected to be adapted to the characteristics of the water in your area. You
can inquire about the water hardness with your local water supplier, or use test strips to determine it.
Test strips are supplied depending on the model or may be purchased from after sales service or
specialist shops (see section "Accessories").
To change water hardness, while the coffee maker is plugged in, proceed as indicated below:
If test strips are used:
- Immerse the test strip in tap water for 2-5 seconds
- Wait for 30 seconds. The number of stripes that turn red indicate the water hardness
Very soft
Soft
MEDIUM
MAXIMUM
45
Werbung
Inhaltsverzeichnis
Fehlerbehebung
