Adjusting User Choices - Zelmer ZCM8121 MAESTRO BARISTA Benutzerhandbuch

Medium
Hard
Very hard
1. If the coffee maker is switched on, touch the icon
to switch it off.
All the indicators will go off.
2. Touch the icon for 3 seconds.
A beep will be heard and indicators will light up showing prese-
lected water hardness. "Very hard" hardness is selected by default
from factory. The indicator of the icon
3. Touch the icon repeatedly for changing water hardness. Indicators located at the base of the
level bars will go off successively with each touch.
VERY HARD HARD
(more than 22ºdH) (15-21ºdH)
4. Touch the icon to confirm your choice.
All the indicators will go off again.

3.3. Adjusting user choices

Maximum water volume dispensed for each kind of drink may be selected and recorded as default
value.
Proceed as indicated below:
1. Touch the icon to switch the coffee maker
on.
Wait until all the indicators light up permanently.
46
will flash.
MEDIUM HARDNESS
(7-14ºdH) (up to 7ºd)
2. Touch the icon corresponding to the drink you
want to prepare for 3 seconds.
3. A beep will be heard. The Indicator of the maxi-
mum setting of the icon
the indicator of the icon
4. Touch the icon
icon is touched again.
Then, water flow will stop and this water volume will be recorded as user
personal choice.
NOTE: water volume range for each kind of drink is:
- Espresso / Steam: 1 - 230ml
- Coffee / Hot Water: 1 - 430ml
It is recommended to fill the water tank previously up to the maximum level to be able to adjust
the maximum volume
Maximum water volu-
me indicator
SOFT
5. After some seconds, all the indicators will light up again.
will light up and
will flash.
. The selected drink will be prepared as usual, until the
Drink Factory default maxi-
mum volume ml
70
200
360
46
Personal choice maxi-
mum volume ml
1 - 230
1 - 430
1 - 430
1 - 230
47