Before Use; Filling With Water - Zelmer ZCM7255 Benutzerhandbuch

EN
Unplug the product immediately from the mains in the event of any breakdown or damage and contact
an official technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from
the brand´s Official technical support service may carry out repairs or procedures on the device.
Eurogama Sp. z o.o. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings
INSTRUCTIONS FOR USE

Before use

Make sure that all the product's packaging has been removed.
Before making coffee for the first time, we recommend using the coffee maker twice with water only, in
order to clean the system.

Filling with water

The water tank (10) must be filled with water before turning the appliance on.
Remove the detachable tank, open its cover (9) and fill the tank. Never fill beyond the level "MAX".
Close the cover.
Replace the tank into the appliance properly.
Pre-heating
To make a cup of good hot espresso coffee, we recommend you preheating the appliance before making
coffee, including the funnel, mesh and cup, so that the coffee flavor cannot be influenced by the cold
parts.
Select the one cup or two cup mesh (18) and place it (without adding coffee) into the metal funnel (17).
Pull the press bar (16) backward and make sure that the funnel aligns with the groove in the water
outlet. Then insert the funnel into the water outlet from the "Insert" position and fix it firmly by turning it
counterclockwise until it is at the "lock" position (Fig.1).
Place a cup on the removable shelf (7).
Make sure that the control knob (11) is at the "OFF" position.
Connect the appliance to the power supply.
Press the "on/off" button (4) to switch the appliance on.
The indicator light (1) will flash in blue color for approximately 2 minutes. After this time, the indicator
light will stop flashing and will remain lit permanently. The warm-up cycle is completed.
Press the "manual cup" button (5) to make the pump work. Hot water will flow out through the funnel to
the cup.
After a time, when you consider that the parts are already pre-heated, press the "manual cup" button (5)
again to stop the water flow.
Make expresso coffee
Remove the funnel (17) by turning it in clockwise.
Add ground coffee to the steel mesh (18) with the measuring spoon (14). Then press the grounded
coffee tightly with the tamper (14). A spoon of grounded coffee can make about a cup of top-grade
coffee.
Pull the press bar (16) backwards and place the corresponding steel mesh (18) for one or two cups into
the metal funnel (17).
Make sure that the funnel aligns with the groove in the water outlet. Insert the funnel into the water outlet
from the "Insert" position and fix it firmly by turning it counterclockwise until it is at the "lock" position
(Fig.1).
10