Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BTL _ _ _ _ _ _ - _ _ _ _ -C1...
Magnetostrictive linear position sensor
3
Overview of IO-Link Data and Functions (continued)
3.5
System Commands
Command Value
Device Action
0x80 (128)
Device Reset – Device Reset means a warm start of the device. During this process, the
microcontrollers are restarted and all initializations performed again without any change made to
the parameter values (see chapter 6.3 on page 65).
0x81 (129)
Application Reset (see chapter 6.3 on page 65)
0x82 (130)
Reset Factory Settings (see chapter 6.3 on page 65)
0xA5 (165)
Maintenance Reset (see chapter 6.3 on page 65)
0xA6 (166)
Switching Counter Reset – Resets counter value and flags.
0xA7 (167)
Statistics Reset – Resets all output parameters to 0 and all user settings to the default values.
0xA8 (168)
Statistics Start Min/Max/Avg – Starts the statistics of the minimum value/maximum value/average
calculation.
0xA9 (169)
Statistics Stop – Stops statistics operation completely.
0xAA (170)
Signal Speed Monitoring Reset – Resets the speed value and flags.
0xAC (172)
Statistics Start Moving Average – Starts the statistics of the moving average calculation.
0xAF (175)
Start Device Discovery
0xC0 (192)
Set Reference Orientation – Sets the reference orientation of the actual position of the device.
Responses: ACK: command successful, reference stored.
0xE0 (224)
Teach Preset – Sets the current measurement value to the value of Measurement Preset.
0xE1 (225)
Teach Lower Limit – Sets the lower end of the measuring range.
0xE2 (226)
Teach Upper Limit – Sets the upper end of the measuring range.
0xE7 (231)
Set Offset Value – Applies the actual position of the first magnet so that 0 is displayed straight
away for this position.
This function is only available in Smart Sensor Profile Legacy variants (with PDIn)
1)
Tab. 3-18: System Commands – Overview
www.balluff.com
1)
english
23
Werbung
Inhaltsverzeichnis
