Bresser Quadro Individio Bedienungsanleitung Seite 17

12 Change room name
NOTICE! The room description cannot be changed when the
time signal search is active (the corresponding symbol
flashes). Wait until the time signal search is completed to be
able to change the room designation.
1. Press the desired ROOM key (1-3) corresponding to the
connected wireless sensor (channel 1-3). The room des-
ignation flashes. Continue with step 2 or 3.
2. Press the ROOM key several times to select one of the 5
preset room designations. Alternatively, continue with
step 3 or wait approx. 5 seconds until the change has
been saved automatically. The display no longer
flashes.
3. Press the MODE button to switch to the entry of a free
room designation. "_" flashes.
4. Press the UP or DOWN button until the desired input
value flashes. Possible input values: blank → 0-9 → A-Z →
< → > → * → + → - → / → _
5. Press the ROOM button again to switch to the next in-
put value and enter it as described under step 4.
6. Finally, press the ROOM button to save the entry. If no
entry is made within 5 seconds, the settings made up to
this point are automatically saved. In both cases, the
display no longer flashes and the free entry is saved.
13 Display change °C/°F
• Base unit
In normal display mode, press the DOWN button to toggle
between °C and °F.
• Wireless sensor
Open the battery compartment.
Press the °C/°F button to toggle between °C and °F.
Close the battery compartment.
17 / 44