ASROCK H610M-ITX/eDP Bedienungsanleitung Seite 28

Serial ATA3 Connectors
(SATA3_0:
see p.1, No. 9)
(SATA3_1:
see p.1, No. 10)
(SATA3_2:
see p.1, No. 11)
(SATA3_3:
see p.1, No. 12)
USB 2.0 Header
(9-pin USB_5_6)
(see p.1, No. 7)
USB 3.2 Gen1 Header
(19-pin USB32_3_4)
(see p.1, No. 8)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 16)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
22
1
USB_PWR
USB_PWR
P- P-
P+ P+
GND GND
DUMMY
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PB_SSRX+
IntA_PA_SSRX-
IntA_PA_SSRX+ GND
IntA_PB_SSTX-
GND
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+
Dummy
1
1
MIC2_L
MIC2_R
OUT2_R
MIC_RET
J_SENS E
OUT2_L
OUT_RET
These four SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
* If M2_1 is occupied by
a SATA-type M.2 device,
SATA3_0 will be disabled.
There is one USB
2.0 header on this
motherboard. This USB
2.0 header can support
two ports.
There is one header on
this motherboard. This
USB 3.2 Gen1 header can
support two ports.
This header is for
connecting audio devices
GND
PRESENCE#
to the front audio panel.