Klarstein PARFORCE DUO 10033296 Bedienungsanleitung Seite 28

EN
28
Problems
Gas leaking between
LP tank and regulator
connection
Fire coming through
control panel
Grease fire or
continuous excessive
flames above cooking
surface
Burner will not light
using ignites.
Possible cause
Improper installation, Turn off LP tank valve, remove
connection not tight, regulator from cylinder and
failure of rubber seal visually inspect rubber seal for
damage, see LP tank test and
connection regulator to the LP
tank
Fire in burner tube Turn off control knobs and LP tank
section of burner due valve. After fire is out and grill is
to partial blockage cold, remove burner and inspect
for spider nests or rust. see natural
hazard and cleaning the burner
assembly pages.
Too much grease Turn off LP Tank. Leave lid open to
buildup in burner area allow flames to die down. After
cooling, clean food particles and
excess grease from inside firebox
area, grease cup/pan/tray, and
other surfaces
Gas issues 1. See instructions on control
panel and section in the Use and
1.Trying to light wrong Care.
burner 2. Make sure valve are positioned
2. Burner not engaged inside of burner tubes.
with control valve 3. Ensure burner tubes are not
3. Obstruction in obstructed with spider webs or
burner other matted, see cleaning section
4.No gas flow of use and care
5.Vapor lock at 4.Make sure LP tank is not empty.
coupling nut to LP tank If LP tank is not empty, refer to
6. Coupling nut ad "sudden drop in gas flow.
LP tank valve not fully 5.Turn off knobs and disconnect
connected. coupling nut from LP tank.
Reconnect and retry.
6. Turn the coupling nut
approximately.
Prevention/ Solution